I was reprogramming a TMS470R1VF288 with new code. (Confession: I am no longer accustomed to this part.) The part erased okay but now it won't program. The erase range was 0 to 0x7ffff. I have since seen that others only reflash 0x40000 to 0x7fffff
Screen output is below:
Flash470 version 3.31 Build v331-2005-12-02-12-34-20 (STABLE - INTERNAL ONLY!!)
Config file C:\TI\flash470\v331-stable\flash470.cfg Version: 3.31
Setup...initialize...reset...halt....complete
Device ID value read=0x00000000
Forcing Device Name="TMS470R1VF288.0"
"TMS470R1VF288 Rev 0"
Device Identification=TMS470R1VF288.0
Target Frequency 16.00 MHz
Configuration file revision 3.31
Algorithm library: f05a.lib, Version 0.32
Error 127 - Unable to set breakpoint.
Press Enter to exit
I tried a different unit and just ran a blank check. It correctly identified the part as not blank. On the unit I am using, I get the error above.
Any suggestions?